Iluminarc Ilumicode™ Addresser Uživatelský manuál stáhnout pdf (Strana 10)

Installation

6 Ilumicode V 2.21 User Manual Rev. 3

3. Installation

Always connect

ILUMINARC®

products to

protected AC circuits with an

appropriate electrical ground

to avoid the risk of

electrocution or fire

Never connect an

ILUMINARC®

product

to a rheostat

(variable resistor) or dimmer

circuit, even if the rheostat or

dimmer channel serves only

as a 0 to 100% switch.

ILUMINARC®

recommends not

connecting more

than 20 products in

this mode, while keeping the

total distance from the

Ilumicode controller to less

than 60 m (197 ft). Otherwise,

you might need to use an

optically isolated signal

amplifier.

Mounting

The Ilumicode V 2.21

is strictly a handheld unit. Therefore, ILUMINARC® does not provide any

mounting harness or mounting instructions for it. Refer to the corresponding product

manual for

instructions on how to mount the compatible ILUMINARC® products.

Power

The Ilumicode V 2.21 uses two (2) AA batteries (included).

DMX Linking

The diagram below shows how to connect the Ilumicode DMX output to any compatible

ILUMINARC® product.

Note that this connection will control multiple products at the sa

me time, all having the same

DMX address. To assign individual DMX addresses to each product

, you must connect the

Ilumicode unit to each product

, individually. This means that you will also have to disconnect the

DMX output of the product under configuration if there are other products connected to it.

1: Gnd (Black Clip)

2: Data – (Green Clip)

3: Data + (Red Clip)

1: Gnd

2: Data –

3: Data +

Power

Signal

Ilumicode

Addresser

DMX Output

Signal Connector

Other

Products

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Komentáře k této Příručce

Žádné komentáře

Iluminarc Ilumicode™ Addresser Uživatelský manuál Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Osvětlení Iluminarc Ilumicode™ Addresser